In addition to the thread stripping coaxial cable stripping machine is not away, there are other common problems, such as severe crush wires of different lengths, the actual line length is not equal to the set line length, etc., stripping machine these problems, we should how to solve, we answer for you. Computer CD-ray machine is also cutting more than two, but when you finish cutting the length of the two divergent samples, adjust the pressure on both sides of the wheel, so cut out two equal length
These FAQs stripping machine is actually not considered a malfunction, the main reason is that there will not properly set up the equipment and devices running time is too long. Line wheel pressure is not enough, and occasionally not open cable head stripping phenomenon. When the wire is now severely bruised, bruised from the line should be checked or round qualifying round, the corresponding pressure regulator small wheels. Line wheel gap is too big, no mechanical pressing health initiatives need to start small tune into the line wheel clearance. Line wheels stolen goods, the need to clean up. Jagged cut out material when: the roller pressure is not small, the pressure adjustment nut to increase pressure.

Insulation thickness of the thinnest point below the minimum standards, or the average thickness is less than the nominal value. The reason failed to produce insulation thickness is line speed, a small amount of plastic extruder, improper mold matching and so on. Cable outer was generated because the bamboo-like electrical, mechanical system instability causes of traction speed, and second mold core is too small, or the conductor diameter uneven. Remedy is to check the mechanical, electrical systems, troubleshooting. Appropriate adjustments to the size of the core, the outer diameter of the control counties evenly as possible over the provisions of the stranding process can use.